=================================================================== = Adaptec Family Manager Set v4.0a Service Pack 4 = = Update Notes = =================================================================== The Adaptec FMS v4.0a Service Pack 4 diskette can be used for fresh or an upgrade driver installation. This diskette replaces any previous driver found on the FMS 4.0 CD, and works in conjunction with previous service packs. Always use the latest applicable service pack. Please refer to the readme file found on the Adaptec FMS 4.0 CD for further instructions on installing these drivers. =================== = Version History = =================== ------------------------- Changes in Service Pack 4 ------------------------- Windows XP: Driver Name: ADPU160M.SYS (Ultra160) Addressed Issues: - SCSI Hard Drive LED now stays off during Standby. - Resolved an issue where the driver only negotiates to asynchronous/narrow speeds to any non-hard disk device (CD, tape drives, etc.). Windows 2000: Driver Name: ADPU160M.SYS (Ultra160) Addressed Issues: - Adds clustering support. ------------------------- Changes in Service Pack 3 ------------------------- Windows 2000: Driver Name: ADPU160M.SYS, ADF6U160.SYS (Ultra160) Addressed Issues: - With non-disk device such as HP Ultrium Tape drive, the driver did not negotiate transfer rate, all subsequent I/O transfers occurred as asynchronous speeds. - Tape I/O certification test failure fix. Windows 98/Me: Driver Name: ADPU160M.MPD (Ultra160) Addressed Issues: - Added \Win98_ME folder and an Ultra160 driver from FMS 4.0 SP1a. ------------------------- Changes in Service Pack 2 ------------------------- NetWare v4.2/5.x: Driver Name: All HAM and DDI files (Ultra, Ultra2 and Ultra160) Addressed Issues: - A completely rewritten OSM layer to remove the redundant CDA layer (provides better peformance and maintainability). - Provides a single OSM and CHIM source code base for all the drivers. - Compatibility with NetWare 4.x and 5.x with the proper CSP’s (no support for NetWare 3.x). ------------------------- Changes in Service Pack 1 ------------------------- Windows 95/98: Driver Name: AIC78XX.MPD (Ultra) Addressed Issues: - Added support for the AHA-3944AUWD host adapter. Windows NT 4.0: Driver Name: AIC78XX.SYS (Ultra) Addressed Issues: - Fixed blue screen error when accessing a tape device with a bad tape cartridge. Driver Name: AIC78U2.SYS (Ultra2) Addressed Issues: - Fixed blue screen error when accessing a tape device with a bad tape cartridge. - An event on the PCI bus could occur where an Adaptec Ultra2 host adapter may fail to respond to a PCI GNT# within 16 clock cycles. This will only happen when the master and target on the PCI bus are doing 64-bit transfers. - SCSI bus starvation was occurring when the bus was fully loaded with devices. It was found that commands were timing out for devices that had lower SCSI ID values. Driver Name: ADPU160M.SYS (Ultra160) Addressed Issues: - The termination setting for channel B on the AIC-7899 was being set incorrectly. The problem is seen only on motherboards in which the AIC-7899 has been designed to control the termination for channel A and B. Motherboards that do not use the AIC-7899 to control the termination of the bus will not see this problem. Adaptec host adapters do not exhibit this problem either. - With five Ultra160 Adaptec host adapters installed in a system, the system will blue screen right before the login screen. Windows 2000: Driver Name: AIC78U2.SYS (Ultra2) Addressed Issues: - The host adapter's SCSI ID in the registry does not correspond to the host adapter's ID set in the BIOS SCSI-Select Utility. Under Windows NT 4, everything behaves correctly. After trying various configurations with different SCSI adapters and driver versions, it appears that the failing case occurs under Windows 2000 when no INT13 devices are attached and the SCSI BIOS is disabled. - An event on the PCI bus could occur where an Adaptec Ultra2 host adapter may fail to respond to a PCI GNT# within 16 clock cycles. This will only happen when the master and target on the PCI bus are doing 64-bit transfers. - SCSI bus starvation was occurring when the bus was fully loaded with devices. It was found that commands were timing out for devices that had lower SCSI ID values. Driver Name: ADPU160M.SYS (Ultra160) Addressed Issues: - The termination setting for channel B on the AIC-7899 was being set incorrectly. The problem is seen only on motherboards in which the AIC-7899 has been designed to control the termination for channel A and B. Motherboards that do not use the AIC-7899 to control the termination of the bus will not see this problem. Adaptec host adapters do not exhibit this problem either. NetWare v4.2/5.x Driver Name: AHA2940.HAM (Ultra) Addressed Issues: - Added support for the AHA-2940UW Pro. Note that this is the first FMS release that will contain a HAM driver for the Ultra/Legacy Adaptec products. Driver Name: AHA2940.DDI (Ultra) Addressed Issues: - Updated the driver definition information file for NetWare NWPA. Driver Name: AIC78U2.HAM (Ultra2) Addressed Issues: - SAF_TE processor devices are now supported. Driver Name: ADPT160M.DDI (Ultra160) Addressed Issues: - Updated the DDI file to support the Adaptec 29160N and 29160LP host adapters in a fresh installation. Driver Name: ADPT160M.HAM (Ultra160) Addressed Issues: - NetWare 5 installation fails installation in a system using RCC chipset. The failure only occurs if an Adaptec 39160 host adapter is in a PCI 66 MHz slot. ------------------ Contacting Adaptec ------------------ A Technical Support Identification (TSID) Number is required for Adaptec technical support. - The 12-digit TSID can be found on the white barcode-type label included inside the box with your product. The TSID helps us provide more efficient service by accurately identifying your product and support status. Support Options - Search the Adaptec Support Knowledgebase (ASK) at http://ask.adaptec.com for articles, troubleshooting tips, and frequently asked questions for your product. - For support via Email, submit your question to Adaptec's Technical Support Specialists at http://ask.adaptec.com. North America - Visit our Web site at http://www.adaptec.com. - To speak with a Fibre Channel/RAID/External Storage Technical Support Specialist, call 1-321-207-2000, Hours: Monday-Friday, 3:00 A.M. to 5:00 P.M., PST. (Not open on holidays) - For Technical Support in all other technologies including SCSI, call 1-408-934-7274, Hours: Monday-Friday, 6:00 A.M. to 5:00 P.M., PST. (Not open on holidays) - For after hours support, call 1-800-416-8066 ($99/call, $149/call on holidays) - To order Adaptec products including software and cables, call 1-800-442-7274 or 1-408-957-7274. You can also visit our online store at http://www.adaptecstore.com Europe - Visit our Web site at http://www.adaptec-europe.com. - English and French: To speak with a Technical Support Specialist, call one of the following numbers: - English: +32-2-352-3470 - French: +32-2-352-3460 Hours: Monday-Thursday, 10:00 to 12:30, 13:30 to 17:30 CET Friday, 10:00 to 12:30, 13:30 to 16:30 CET - German: To speak with a Technical Support Specialist, call +49-89-456-40660 Hours: Monday-Thursday, 09:30 to 12:30, 13:30 to 16:30 CET Friday, 09:30 to 12:30, 13:30 to 15:00 CET - To order Adaptec products, including accessories and cables: - UK: +0800-96-65-26 or fax +0800-731-02-95 - Other European countries: +32-11-300-379 Australia and New Zealand - Visit our Web site at http://www.adaptec.com.au. - To speak with a Technical Support Specialist, call +612-9416-0698 Hours: Monday-Friday, 10:00 A.M. to 4:30 P.M., EAT (Not open on holidays) Japan - To speak with a Technical Support Specialist, call +81-3-5308-6120 Hours: Monday-Friday, 9:00 a.m. to 12:00 p.m., 1:00 p.m. to 6:00 p.m. TSC Hong Kong and China - To speak with a Technical Support Specialist, call +852-2869-7200 Hours: Monday-Friday, 10:00 to 17:00. - Fax Technical Support at +852-2869-7100. Singapore - To speak with a Technical Support Specialist, call +65-245-7470 Hours: Monday-Friday, 10:00 to 17:00. - Fax Technical Support at +852-2869-7100 ------------------------------------------------------------------- (c) 2002 Adaptec, Inc. All Rights Reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without prior written consent of Adaptec, Inc., 691 South Milpitas Blvd., Milpitas, CA 95035.